Rule library
WarningField 12.011Subject
UAD1095 — Provide the finished area of the outbuilding, even if the value is 0.
Where this rule lives in the report
Outbuilding
Total Area
Detail
Report Section and Report Subsection as the GSEs define them — the black tab and grey bar you already read on the URAR.
- Severity
- Warning — flagged but does not block delivery. Reviewers will still look.
- Triggered when
ImprovementType = "Outbuilding" and OutbuildingRealPropertyIndicator = "true" and StructureExcludingVehicleStorageAndADUFinishedAreaMeasure is not provided in a given instance of STRUCTURE_DETAIL- Data Point Name
StructureExcludingVehicleStorageAndADUFinishedAreaMeasure- Unique ID
0300.0112- Report Field ID
12.011- What this field means
- A measurement that specifies the finished area of the structure, excluding the finished area within the detached garage and the finished area from any accessory dwelling units present in the structure. The applicable unit of measurement is specified by the Area Unit Of Measure Type.
How to fix UAD1095
UAD1095 is a UAD 3.6 Warning edit; it may not block delivery, but it is still worth resolving before review.
- 01Open the Outbuilding › Detail › Total Area area of the URAR and find Total Area.
- 02Check the condition that triggers UAD1095: ImprovementType = "Outbuilding" and OutbuildingRealPropertyIndicator = "true" and StructureExcludingVehicleStorageAndADUFinishedAreaMeasure is not provided in a given instance of STRUCTURE_DETAIL.
- 03Review and correct the value when appropriate; this is a Warning, but it can still raise reviewer questions.
- 04Use the official Single-family + ADU (SF3) sample value on this page as a reference pattern, then re-run validation.
This fix guidance is derived from the published rule message, trigger logic, report location, field definition, and official sample data available for this rule.
Seen in the sample reports
How this field is populated in the official UAD 3.6 sample scenarios.
0Subject200Subject