Rule library
WarningField 10.032Subject
UAD1185 — Provide the unfinished area of each level in the living unit.
Where this rule lives in the report
Unit Interior
Area
Report Section as the GSEs define them — the black tab and grey bar you already read on the URAR.
- Severity
- Warning — flagged but does not block delivery. Reviewers will still look.
- Triggered when
(ImprovementType = "Dwelling" or (ImprovementType = "Outbuilding" and OutbuildingRealPropertyIndicator = "true" and AccessoryDwellingUnitIndicator = "true")), and LevelUnfinishedAreaMeasure is not provided in a given instance of LEVEL- Data Point Name
LevelUnfinishedAreaMeasure- Unique ID
0700.0138- Report Field ID
10.032- What this field means
- A measurement that specifies the total unfinished area of the level in the living unit. The applicable unit of measurement is specified by the Area Unit Of Measure Type.
How to fix UAD1185
UAD1185 is a UAD 3.6 Warning edit; it may not block delivery, but it is still worth resolving before review.
- 01Open the Unit Interior › Area area of the URAR and find Area.
- 02Check the condition that triggers UAD1185: (ImprovementType = "Dwelling" or (ImprovementType = "Outbuilding" and OutbuildingRealPropertyIndicator = "true" and AccessoryDwellingUnitIndicator = "true")), and LevelUnfinishedAreaMeasure is not provided in a given instance of LEVEL.
- 03Review and correct the value when appropriate; this is a Warning, but it can still raise reviewer questions.
- 04Use the official Single-family (SF1) sample value on this page as a reference pattern, then re-run validation.
This fix guidance is derived from the published rule message, trigger logic, report location, field definition, and official sample data available for this rule.
Seen in the sample reports
How this field is populated in the official UAD 3.6 sample scenarios.
230Subject72Subject